Oppgradering for den kresne som vil ha absolutt maks ut av riflen sin!
Marauder er en kanon rifle, men dette er muligheten for å gjøre den hakket bedre. Med denne regulatoren får du skikkelig konsistent utgangshastighet!
På bilde 4 er regulator montert på blå graf, mens det skytes uten regulator med samme skudd på den røde.
På bilde 5 er regulator skrudd ned til omtrent 110 bar, og en kan få ut vannvittig mange skudd med konsistent utgangshastighet.
Innstalasjonen er enkel, og alt passer sammen. Under står produsentens fremgangsmåte. Skulle du være i tvil, ring oss!
1) Unscrew airtube
2) Mount regulator
3) Set regulator
1) Before removing plug we need drain all air from airtube, we can shoot without pellets for drain air. Unscrew couple between airtube and barrel, than remove the plug itself. For removing plugs can be used pliers, or we can use coupling us lever.
2) After unscrewing plug is necessary to unscrew the handle with a manometer. Screw the installation stick to the regulator and check o-ring, if is clean and not damaged. Spray o-ring with silicone spray for preventing any damage. Insert regulator handle to the bottom of airtube into center hole. Regulator handle insert only to a depth that you can see o-ring in the hole after removed manometer. Than pushing trought manometr hole on o-ring ( with wreng, or other blunt obejct that will not cause damage to o-ring) and push regulator with circular motion to the bottom.
In the event of a leak around o-ring on the handle will unregulated pressure penetrate in to regulated part and even the regulator is functioning properly, output pressure will be unregulated. This is the most common reason for poor consistency after installing the regulator, which is considered us malfunctioning regulator, which is bad consideration because error is in installation, or in uncleanness on the o-rings (which are between the regulator and the chamber, or between the chamber and handle of regulator). O-rings between the parts and regulator has to be easily squieezed between the walls (not too squashed). Remove the installation stick and screw the plug back into the airtube. Attach back coupling and everything is done. After installing regulator will be manometr still show pressure in airtube, not regulated pressure.
Guidance, extended manuals and video tutorials in english can by found on www.altaros.cz
3) The pressure setting is done by using a flat screwdriver in the upper part of the regulator. When we setting regulator we rotate with inside plastic screw with groove. The output pressure is showed by location colored grooves on the inner plastic screw. The total rotation range of the output pressure is in the range from 100 to 150 bar and is approximately 1/2 turn.
Scale is starting on 100 bar (green color) and ends on 150 bar (red color). Scale is only approximate and course times may change slightly due to fatigue disc springs. Fill the airtube to the maximum pressure which is mentioned by manufacturer.
